Hydrotech Acquires Isaacs
Hydrotech ecommerce supports the continental US only

SUN HYDRAULICS CORP
XRAGLANHA/S311
Circuit Savers

Y-assembly

SUN HYDRAULICS CORP

MATERIAL:  XRAGLANHA/S311

SUMMARY:  Y-assembly

Due to extremely high demand, please call 888-651-5712 for availability

This assembly consists of a direct-acting relief cartridge which are normally closed, pressure-limiting valves used to protect hydraulic components from pressure transients. When the pressure at the inlet (port 1) reaches the valve setting, the valve starts to open to tank (port 2), throttling flow to limit the pressure rise. These valves are smooth and quiet, essentially zero leak, dirt tolerant, immune to silting and are very fast. The 2-way, 2-position solenoid directional valve provides a means to unload (bypass the relief valve) the system.

  • Back pressure on the tank port (port 2) is directly additive to the valve setting at a 1:1 ratio.
  • Suitable for use in load holding applications.
  • This assembly provides protection for pumps and motors from pressure transients due to sudden load changes, especially variable displacement pumps, since the displacement mechanism is sometimes too slow to catch these pressure transients.
  • The assembly's direct acting relief valves exhibit rapid response characteristics that minimize pressure overshoot and also provide low reseat leakage (less than 5 drops/min (0,3 cc/min) @ 85% of cracking pressure).
  • The seals on the adjust screw are exposed to system pressure which means this valve can only be adjusted when the pressure is removed. The setting procedure is; check the setting, remove the pressure, adjust the valve, check the new setting.

Capacity.25 gpm1 L/min.
Body TypeLine mountLine mount
Mounting Hole Diameter.34 in.8.6 mm
Mounting Hole Thread.250-20 UNC - 2B in..250-20 UNC - 2B in.
Mounting Hole DepthThroughThrough
Mounting Hole Quantity11

Show FAQ

Additional Resources



Notes:
  • Important: Carefully consider the maximum system pressure. The pressure rating of the manifold is dependent on the manifold material, with the port type/size a secondary consideration. Manifolds constructed of aluminum are not rated for pressures higher than 3000 psi (210 bar), regardless of the port type/size specified.